Elevator bucket hopper with:
The elevator bucket is the use of the hopper with the first round of the friction torque between the drive shaft to the elevator materials, and thereupon the hopper belt tension is not enough, will result in the hopper with skid. In this case, you should immediately shut down, adjust the tensioning device to tighten the hopper with. If the tensioning device can not make the hopper with a completely tension, the trip was too short of the tensioning device, should be re-adjusted.
The correct solution is:
Untie hopper connector with the tensioning device on the end of round raised to the highest position, the hopper into the band by the hoist head through the first round and bottom round, and connected end to end, so that the hopper with in the tensioner tension state. Then the tensioning device completely tension. The tension stroke adjustment screw of the tensioning device untapped should not be less than 50% of the whole trip.
Slip of the performance:
The hoist overload overloading of the hoist, the moment of resistance increases, leading to the hopper with skid. Should reduce the feed rate of the material, and strive to feed evenly. Reduce the feed rate, still can not improve the skid, it may be the accumulation of material inside the machine to sit too much or hopper be mentor object stuck down to check, troubleshooting.
Solution:
The first round of the drive shaft and hopper band surface is too smooth, too smooth surface of the first round of the drive shaft and hopper band, so that the friction between the two decreases, resulting in the hopper with skid. At this time, the drive shaft and hopper band coated with a layer of glue to increase the friction.
